| The Vortex Mod was the FIRST hard-coated and teflon impregnated aluminum internals to replace the stock plastic internals of the Tippmann Cyclone Feed to be released in the paintball industry. The Vortex Mod SS now incorporates a stainless steel axle and design changes to make it the most durable and easiest upgrade to install.
The popularity of electronic controls in Tippmann A5, X7, and 98's that allow for rates of fire of up to 30 BPS, has warranted the need for higher performing internals for the cyclone feed that will allow the loader to keep up with the marker.
Our testing has shown that the Vortex Mod will allow the Cyclone feed to work at lower pressures, feed faster, and last longer than the stock plastic cyclone feed internals.
While stock cyclone internals need to be replaced on a regular basis, the Vortex Mod is a permanent solution that makes the cyclone faster and more reliable.
Since its release, the Vortex Mod has been the most widely used, and most trusted name in cyclone upgrades. The Vortex Mod is specifically designed to be the fastest, smoothest actuating, and most durable/long lasting upgrade available.
The "Genuine" Vortex Mod is by far the most durable and highest performing cyclone upgrade available. If it wasn't, we would redesign it to crush the competition...again.
The Vortex Mod will feed upwards to 30+ balls per second and continue to load down to pressures as low as 150psi.
Stock parts only feed up to 15 balls per second and only down to a pressure of 400 psi. |
